LAZERTOYZ *Lite R/C lighting system V3 Landing
Light On and Off
Transmitter Controlled RC Airplane Navigation Lights, Strobe, and
Landing Lights with auxiliary output.
Thank
You for purchasing the most advanced and versatile RC navigation light system
available. Your Light Screamer will give many hours of operation as long as you
read and follow the directions
carefully.
Each unit comes
ready to install on your model. Just take the servo connector on the light
system and plug it into and extra channel output on your receiver, if you do
not have an extra output you may use a “Y” connector in any channel that you
can give it full controls to get it into the right mode. When you turn the
Transmitter and receiver on, toggle your
joystick or switch that the Lite system is hooked to and your lights should
react by changing modes. Once you have your LED lights positioned and the
connector plugged into the channel you want on the receiver. All you need to do
is move the joystick (or switch) from low to high position, it will then change
modes of the lights (see chart below). First just the strobe light then toggle
the stick and you have your position lights, move again and your landing lights
will come on, it will then restart the sequence with the next toggle. .
You may add lights in
Parallel to the wires but keep you polarity correct (Red wire connects to Red
and Black to Black). The wires should be color coded with black negative and red
positive Double Check this with the polarity diagram below.
You may attach up to 5 bright LED’s to each of the 5 outputs Only
use Lazertoyz.com lights because there are different voltage drops on lads,
also only use the same color LED’s on the wire do not mix colors as it will
degrade brightness . For correct scale flight
the Red light goes on the left wing as you are the pilot sitting in the cockpit
and the Green light is mounted on the right wing.
Lights
may not come on till you move the Joystick or switch once.
The Auxiliary output
will trigger when in the high position and off in the low position. This is the
light on the main control board you may add lights to that output or use it for
a 5 volt relay(email us for directions to add a rely).
You may add lights of the same type and color in par Although our unit will handle many more your BEC may
not. Check your ESC & receiver
specs for ratings . The flat on the LED indicates the Negative Polarity
side
|
Lite R/C lighting system by
Lazertoyz OPERATION |
|
||||
|
CONTROL ACTION |
POSITION Red & Green Output 1 & 2 |
LANDING LIGHT White Output 3 |
STROBE LIGHT White Output 4 |
Auxiliary On Circuit Board... Output 5 |
NOTES |
|
|
|
|
|
|
|
|
Power On first signal |
Off |
Off |
Off |
Off |
|
|
Switch or Joy High |
On Solid |
ON SOLID |
On Blink |
On |
Mode 1 |
|
Switch or Joy Low |
On Solid |
ON SOLID |
On Blink |
Off |
Mode 1 |
|
Switch or Joy High |
On Solid |
Off |
On Blink |
On |
Mode 2 |
|
Switch or Joy Low |
On Solid |
Off |
On Blink |
Off |
Mode 2 |
|
|
|
|
|
|
Back to Mode 1 |
